I. Surface Preparation

All surfaces must be considered dirty and must be cleaned prior to the application of vinyl. Recommended cleaning procedures for specific surfaces are listed below.

A. Plastics & Glass

Clean the surface with glass cleaner such as Windex Window Cleaner. Wipe the surface dry with a clean, dry, lint-free cloth.

B. Painted Metals and Base Metals

These surfaces should be cleaned using an automotive detergent such as Turtle wash, do not use dish detergent. Wipe the surface dry with a clean, dry, lint-free cloth. Freshly painted surfaces must be allowed to dry for one week prior to application.

C. Interior Painted Surfaces

Paint must be allowed to dry for one week prior to application. Clean the area where the markings are to be applied with a household cleaner such as 409. Rinse thoroughly and dry.

II. Temperature Requirements

Air and application surface temperatures must be above 55°F.

III. Application Instructions

A. Use 1”-2” strips of masking tape B. Apply horizontal tape at the top

to position marking in proper registry. of the marking.

C. Remove liner entirely and allow marking D. Remove premask at 180° (pull back

to drape. Using firm initial squeegee on itself)

pressure, begin at top center and work

down and outward to each edge of mask. E. Resqueegee entire marking.

We at EuroPDR hope this instruction guide was helpful. If there are any questions or comments, please contact us at (678) 644-0005. email signs@europdr.com.